Project

General

Profile

DAQ in GANIL

DAQ network for AGATA is used in 3 locations:
  • room 19 (preprocessing and DAQ room)
    • Network backbone
    • Computing farm
    • ATCA crates
    • GTS crates
  • AGATA users room
    • GANIL network racks
    • Visu machines
  • G1 (experimental hall)
    • Network to control digitizers

Computing racks

3 racks:
  • disks and anodeds
  • network services and anodes
  • anodes

-> Images des racks + description ...

Network configuration

Dell switch configuration to enable unregistered multicast flooding
console>
console>enable
console#config

console(config)#ip igmp snooping unregistered floodall
console(config)#do write

Switch connections

  • Anode 14 is connected to one side of the switches stack - DAQ
  • Anode 17 is connected to one side of the switches stack - SERVICES
OBSOLETE
Some additional link:

Backbone (HP switch)

_ID _Name _Definition
1 Default Default port. Used if not in an other VLAN.
2 Dataflow Ports dedicated to dataflow. Must be used only by narval !
10 SC1 Ports dedicated to control the electronic of the "second virtual detector".
11 SC2 Ports dedicated to control the electronic of the "second virtual detector".

General Cabling

A1 -> A20 : services for anode01 to anode20
C1 -> C20 : services for anode21 to anode40

B1 -> B20 : dataflow for anode01 to anode20
D1 -> D20 : dataflow for anode21 to anode40

Take care : anode27 = anode master !

A21/B21 -> anodeds1
A22/B22 -> anodeds2
C21/D21 -> anodeds3
C22/D22 -> anodeds4

F1 : lxagata1
F2 : lxagata0
F3 : janus1
F4 : janus
F5 : marsouin2
F6 : marsouin
F7 : sunxfire

Preprocessing switches

PHOTO

Smaller port number is connected to the first card of the corresponding ATCA crate, larger port number is connected to the last card of the corresponding ATCA crate.

Interface with GANIL

Cable labelled :
  • DMZ is used to connect AGATA gateway to the DMZ network of GANIL
  • digiG1 are used to connect SC network to the digitizer through the switch racks in the AGATA users room.
  • phys is used to connect AGATA service network to the switch in the AGATA users room (and to provide access to the DAQ box from this room)